Manual CCV IM30
Rev.07
9 / 25
© CCV GmbH - Diese Unterlage darf ohne unsere Zustimmung nicht vervielfältigt oder weitergegeben werden.
This document must not be copied or distributed without our approval.
5
Installation
The CCV IM30 is designed to be mounted on vertical surfaces by means of a mounting plate. Depending on
the size of the cut-out on the front of the vending machine, installations can be made using a special mounting
plate. Two variations are described below.
The following three figures summarise the main dimensions of the CCV IM30 terminal.
5.1
Installation based on the Standard cut-out („Kiosk cut-out“)
For installations based on the standard cut-out with the
dimensions W x H (mm): 82.40 +0.10/-0.00 x 120.40
+0.10/-0.00 the Kiosk frame can be used for mounting
the terminal. This has the CCV part number 03443-55.
The illustration on the right shows the terminal rear
view including positioning of the holes for mounting the
terminal.
Attention:
Also with this form of terminal mounting, the
4xM4 screws on the back of the terminal must be done
with a force torque of 0.3Nm to max. 0.4Nm.
56.7
