5
The PSU for the transmitter needs to be capable of supplying 12v D.C. @ 200mA continuously. The PSU for the receiver needs to be
capable of supplying 12v D.C @ 350mA. Please ensure you use a fully regulated power supply or you risk damaging the Mules.
The Mules have a green 2 Pin connector that connects power to the units, both the Tx and Rx are clearly marked with the correct
connection polarity. The red core is +12V and the black is 0v see figures 4 and 5.
Please make sure that you check the polarity of the power supply that you are using to ensure the power is connected correctly. Once
power is applied to the Mules the power LED will light up and stay lit.
Powering the Units
Tx
- Transmitter
Figure 4
Rx
- Receiver
Figure 5
The Mules require a 12v power supply to power the units, so you will require 2
power supplies. One for the transmitter and one for the receiver.
Installation
The units have wall mount fixings lugs either side for internal installation however for
external installation the Mules MUST be installed in a suitable IP rated enclosure such
as the BOX420 (figure 3).
Figure 3
WARNING
POLARITY
SENSITIVE
Step 3
- fasten the unit to a wall
Step 4
- power the units.
CCTV Mule Instructions
