CBSArcSafe.com
|
Email: [email protected]
A Group CBS Company
CBS
Safe
®
Arc
4.2 Sequence of Operation:
1. Connect the control cable to the actuator and to the
hand-held controller.
2. Both plungers should be in the retracted position.
If they are not, DO NOT install the actuator on the
breaker. Doing so could inadvertently TRIP or CLOSE
the breaker.
3. Install the actuator on the breaker as described in
Section 4.3
4. Ensure you are at a safe distance from the circuit
breaker that is to be operated.
5. When ready to operate the breaker, press and hold
the ENABLE button and then press and hold the
appropriate button for the desired operation – either
OPEN or CLOSE. Both the Enable and OPEN or CLOSE
buttons must be pressed and HELD until the plunger
extends far enough to operate the breaker. If either
button is released, the plunger will not complete the
stroke and will retract immediately.
4.3 Attaching and Removing the Actuator:
The Chicken Switch
actuator opening will
align on this raised part of
the SPB breaker.
The area shown in
BLUE
must be free of lamicoid
nameplates or anything
that would prevent the
actuator from seating
firmly over the face of
the breaker. Any such
obstructions will need
to be relocated to allow
proper installation of the
actuator.
To attach the actuator, complete the
following steps:
STEP 1:
Align
opening in actuator
over the raised
portion on the face
of the breaker.
STEP 2:
Rotate
the upper magnet
lever upward to latch
magnet onto breaker
door.
STEP 3:
Rotate the
lower magnet lever
downward to latch
magnet onto breaker
door.
NOTE: Obstructions such as lamicoid nameplates on the
front of the breaker or on the breaker door above or below
the breaker may interfere with installing the actuator.
These obstructions may have to be relocated to allow for
proper installation.
To remove the actuator: :
Hold the actuator
firmly as shown
in the picture on
the previous page
and rotate the
lower magnet lever
upward and rotate
the upper magnet
lever downward
to disengage both
magnets.
The actuator can then
be gently pulled away
from the breaker.
This picture shows how to operate magnet lever to release
magnet.
NOTICE: The Chicken Switch® is designed as a portable
device. It is not designed to remain with the control unit
connected to the actuator for extended periods of time. To
do so will deplete a fresh set of batteries in a short amount
of time.
