877-4-SAFETY
|
Fax: 940-382-9435
A Group CBS Company
CBS
Safe
®
Arc
of 3.0VDC. The 17 total cells are packaged within the one
replaceable battery pack. The 22.5VDC output is fused in
the middle of the string to limit the current to 4.0 amps.
The two following battery types are offered with RSK-ABL1:
Lithium/Iron Disulfide – this battery pack has been
tested to 3,000+ operations before needing replaced.
The individual cells have an advertised shelf life of
10-20 years depending upon the storage temperature.
The advantage to this battery is that it is long lasting
and will not require replacement as often as an
alkaline battery. The disadvantages are that there
are regulations that in certain circumstances could
prevent shipping or transporting them by air freight
and internationally. See Federal 49 CFR 173.185
and IATA regulations for additional information
for shipping and transporting Lithium batteries.
See Section 7.0 for additional specifications.
Alkaline – this battery pack has been tested to 1,500+
operations before needing replaced. The individual
cells have an advertised shelf life of one year, which
is the dis-advantage of this battery. The advantage is
that is can be easily shipped by air or internationally.
The type of battery installed in your RSK-ABL1 could
be either the Lithium/Iron Disulfide type or the
Alkaline depending on which type was ordered. The
type of battery installed in your RSK-ABL1 can be
determined by the label on the side of the battery.
Both types of battery packs are custom designed
to work with the RSK-ABL1 and are only available
through CBS ArcSafe. Use only approved battery
packs. CBS ArcSafe can provide assistance to assure
that you order the correct battery. See Section
8.0 for information to contact CBS ArcSafe.
RTL-1 Remote Transmitter
The RTL-1 is a remote transmitter used with the
wireless version of the RSK-ABL1. It is powered by
a 9VDC battery. Replace this battery as needed
with a commercially available 9VDC battery. An
alkaline type is recommended, but not required.
RCL-1 Remote Controller
The RTL-1 is a remote controller used with the cabled
version of the RSK-ABL1. It is powered from the RSK-ABL1
actuator through the cable and does not contain a battery.
3.1 Removing and Replacing the
Battery in the RSK-ABL1 Actuator
The RSK-ABL1 actuator requires a custom
battery. Do not attempt to use a non-approved
battery. To obtain a replacement battery, see
Section 3.0 for detailed information. To replace
the battery, complete the following steps:
STEP 1: Using Phillips screwdriver, remove
four screws from battery cover plate.
STEP 2: Remove battery cover plate and slide battery out.
