VRC2100 Vending Reader
3
Installation Guide
3 Installation
WARNING:
To avoid personal injury or death, disconnect all power
from the vending machine before proceeding with this installation.
Do not attempt to perform this procedure unless you are experienced in
the repair and installation of complex electrical equipment.
3.1 Install the VRC2100 Vending Reader
Use the following procedure to install the VRC2100 Vending Reader:
1.
Remove power from the vending machine.
Magnetic Stripe Insert Version Contactless Version
2.
Install the VRC2100 into a spare bill acceptor or card reader opening
in the vending machine.
3.
Plug the MDB cable supplied with the VRC2100 into the MDB
connector on the back of the reader.
4.
Unplug the nearest MDB connector, such as the one going to the
coin changer, and plug the VRC2100 MDB cable in-line between the
coin changer and the cable that previously was going to the coin
changer. Route the MDB cables to avoid pinching or pulling.
5.
Plug one end of the network cable supplied with the VRC2100 into
the network jack on the back of the reader. Route the cable safely out
the back of the vending machine and plug it into a nearby 10/100
Base-T campus network jack.
