CBE PC380-ST, User Manual

Page: 19 / 52

FUNCTIONS
The electronic battery protection device disconnects
the 12V users when leisure battery reaches 10V
and disables: pump, lights,
, stove. awning light
It is possible to connect all users for one more
minute by pressing the on/off button (ref. 5 on
control panel).
When car battery voltage goes below 12V Car
Battery Discharge alarm goes on and the symbol
ref. 16 starts blinking. ,
When leisure battery voltage reaches 11.5V the
leisure battery reserve alarm goes automatically on,
the symbol ref. 17 starts blinking, you hear a short
beep.
graphically by the level guage ref. 2.
a) Fresh water tank with electronic probe:
visualization in % (steps of 10%) and
When the leisure battery voltage reaches 10.5V, the
Leisure Battery Discharge alarm goes automatically
on, the symbol ref. 17 starts blinking, you hear two
short beeps.
A fresh larm turns on when water level goes below
1 % of the tank capacity and automatically turns off
when level exceeds 2 %. 0
0
Alarm goes off when the voltage goes above 12.5V.
LEISURE BATTERY ALARM (B2)
CAR BATTERY ALARM (B1)
Alarms go off when the voltage goes above 12.5V.
MINIMUM VOLTAGE CONTROL (BATTERY
PROTECTION)
Symbol ref. 15 is the visual alarm signal.
The control panel automatically turns off with a
voltage lower than 9.5V.
Users are automatically reconnected with a voltage
higher than 13.5V.
This device doesn’t control the the 12V users
connected directly to the leisure battery B2
.
TANKS
b) Waste water tank with screw probe.
FRESH WATER TANK ALARM
A ,
( blinking)
larm is acoustic (when engine is off) visual
symbol ref. 13 .
Alarm is shown acoustically (when engine is off)
and visually with the symbol ref. 14 blinking.
FRESH WATER TANK REFILLING
WASTE WATER TANK ALARM
Alarm turns on when the waste water level exceeds
the screw sensor level.
T fresh his function is used during the water
refilling and indicates the water level during refilling.
ref.7 for more than 2 seconds, until the “water
refilling” is displayed on the screen.
To activate this function press the “test tank” button
The control panel beeps in order to warn that tank is
getting filled: one short beep at 75%, two short beep
at 5% and a long beep at 95%. 8
T 7 8 o exit this function press buttons ref. or .
“SETTING”. o reset alarm press any test button; T
DIGITAL CLOCK
- Both int. and ext. temperatures have a sensor,
An electronic device switches off the awning light
ALARM CLOCK
To set and activate/deactivate the alarm clock see
which is placed inside or outside of the vehicle.
when engine is turned on.
AWNING LIGHT AUTOMATIC TURN OFF
there is no delayed alarm!
TEMPERATURE
To set clock see “SETTING”.
- The precision of the temperature value is ±1°C.
In a “night” situation, a sensor positioned near the
TWILIGHT FUNCTION
automatically be reduced to the level preset by the
user (to set see SETTING).
display causes the intensity of the LED backlight to
19
EN