GB
E
N
G
L
IS
H
GB
7
REMOTE CONTROL
1-
2-
Complete switch On/Off of the burglar alarm system.
Switch Off/On of the volumetric sensors (only with the alarm
system completely turned on).
Function
Operation
Signal
- Complete alarm system switch-on
(perimeter co volumetric
sensors).
- Complete alarm system switch-off
(perimeter co volumetric
sensors).
- Volumetric sensor switch-off (only
with alarm system ON).
- Volumetric sensor switch-on (only
with alarm system ON).
- A short turn signal flash plus a
short beep of the buzzer.
- Two short turn signal flashes plus
two short beeps of the buzzer.
- A long turn signal flash and a long
beep of the buzzer.
- A short turn signal flash plus a
short beep of the buzzer.
- Long press on button ref 1.
- Short press on button ref 1.
- Short press on button ref 2.
- Short press on button ref 2.
Memorisation must be done after the system has been installed on the vehicle.
The alarm system can be linked to max 6 remote controls.
To memorise the remote control, act as follows:
-
short pressure on the button “ref.A” at the rear of the burglar alarm system card;
-
immediately after, long pressure on either of the two buttons on the remote control;
-
to be certain the remote control has linked to the alarm system, turn the system On and Off using the
remote;
-
if switch-on and switch-off fail, repeat the operations.
REMOTE CONTROL MEMORISATION
If the range of your remote control decreases, you can replace the battery in the remote as follows:
- open the remote control by levering off the cover, using the slot near the key holder carrier eye;
- remove the old battery and put in a new one of the same type (3V CR2032 9mA).
- close the remote control being careful not to damage the plastic hooks inside.
ON
OFF
1
2
“Ref.A”
Summary of Contents for MODULO ANTIFURTO
Page 2: ......
