5
Counter Sinks
Remove Screws (x4)
5
VOLTAGE & MAX WATTAGE
Color Camera 95mA (Max) @ 12VDC
Warning:
All cameras are powered by DC voltage.
If you are running DC voltage over a pair of wires,
be careful of polarity. A barrel plug connector
with flying leads is provided. The white/black wire
corresponds to the core of the connector, and should be
supplied with +12VDC voltage. The black wire corresponds
to the shell of the connector, and should be used as DC
ground.
6 DISASSEMBLY
6.1 Cover Removal
1. Remove the unit from its packaging. Cut open one end of
the plastic tubing covering the Height Strip. Leave the
window masks in place.
2. Using a No. 2 Cross Recessed screwdriver, remove all four
screws that secure the cover (see
Figure 2
). Remove
cover.
6.2 Camera Removal/Relocation, and
Installing Accessory Camera
1. Each Height Strip ships from the factory with a single
camera installed that looks through the viewing window
located at the 5-1/2 foot mark. Two other viewing
windows are provided at the 4-1/2 foot mark and 6-1/2
foot.
2. To relocate the existing camera, use a 5.5mm (or 7/32”)
nut driver to remove the M3 nut that attaches the
camera bracket to the base (see
Figure 4
). Remove the
camera and bracket from the base.
3. When installing a new camera or relocating the existing
camera, always refer to the keyhole to ensure the camera
is not installed upside down. The circular part of the
keyhole should face the ground and the slot should face
the ceiling. Always install the camera
above
the desired
pem stud in the base.
4. Accessory cameras require the own power supply. Do not
double terminate the supplied power adapter.
5. Install all front-facing cameras before proceeding to the
next section.
6. To install a side-mounted camera, refer to the
“
Installation – Side-Mounted Cameras”
section
.
Front-Mounted
Camera Position
Side-mounted
camera position
Base
Front-Mounted
Camera Position
Camera
Bracket
Cover
Keyhole
Use a 5.5mm or
7/32” nut driver
to remove or
install cameras.
Front-Mounted
Camera Position
Side-mounted
camera position
Pen Stud
for Side-mounted
Camera
Pen Stud for
Front-mounted
Camera
Flat Washer
M3 Nut
Push here to
adust the
camera’s viewing
angle
Pen stud
for side-mounted
camera
Camera Bracket
Keyhole
Figure 2 Assembled Height Strip Camera
Figure 3 Internal View Camera Postions
Figure 4 Close up View Camera Position
