Installation Instructions for CS4.2PII & CS 8.2PII Video Switcher
1) IMPORTANT SAFETY INSTRUCTIONS
Before commencing with the installation of this equipment read these instructions carefully
and act on the information provided.
Never attempt to gain access to the equipment without first disconnecting the mains supply
to the unit. Consideration should be given as to the correct installation of the unit. The
equipment has been designed for indoor use only and must not be installed in any situation
where air flow around the unit is restricted, where there are strong heat sources (such as
intense direct sunlight, radiators etc.) or in areas of extreme cold.
Before siting the unit, ensure that the user can operate the equipment comfortably without
causing repetitive strain. Each unit has been designed to minimise the amount of user
fatigue that may be caused during normal operation.
Never operate the equipment with damp or wet hands. Do not push any objects into
openings .Do not use the equipment whilst drinking or allow the equipment to be used near
to areas which may get wet. Spillages will invariably cause damage to the unit and may
result in personal injury.
Only use the power supply unit that was supplied with your switcher. Do not use this power
supply for any other purpose. Failure to comply may result in damage or serious injury
2) Unpacking
Carefully unpack your video Switcher. Your package should contain the following items:-
1 off Video Switcher (CS4.2PII or CS8.2PII)
1 off 12v DC Power Supply Unit
1 off RJ45 Terminal Box
1 off RJ45 Interface Lead 1m long
These Instructions
If any item is missing or damaged DO NOT ATTEMPT TO USE THIS EQUIPMENT. Contact
your supplier immediately. Retain the packing material.
3) Product Description
The CS 4.2PII and CS8.2PII are video switchers capable of switching upto 4 or 8 cameras
to two fully independent monitor outputs.
Spot selection of any camera to either monitor is possible and both monitors can be running
different sequences of cameras simultaneously.
Synchronization of camera sequence switching to a VCR head pulse is possible on the
Monitor B output.
They are designed to be desk-mounted and are 'Telemetry Ready' i.e. they can transmit
coaxial telemetry data to functional cameras, only requiring the addition of CS TXP or CS
TXPJ telemetry keypads.
3
