Page
3
of
20
TROUBLESHOOTING
SYSTEM DOES NOT RUN:
1.
CHECK POSITION OF POWER SWITCH ON ELECTRICAL CONTROL PANEL
2.
VERIFY POWER SOURCE VOLTAGE MATCHES SWITCH SETTING
3.
FOR AC POWER (120 VAC/230 VAC) CYCLE THE GFI SWITCH (PRESS “TEST” BUTTON
THEN “RESET” BUTTON)
4.
DISCONNECT POWER AND CHECK ALL WIRING CONNECTIONS (INCLUDING THAT
BETWEEN POWER SUPPLY CONTROL BOX AND PUMP)
5.
IF PUMP IS HOT FROM PREVIOUS USAGE, ALLOW TO COOL (PUMP’S THERMAL
PROTECTION SWITCH WILL DISABLE POWER TO PREVENT DAMAGE)
SYSTEM DOES NOT PRIME (NO SUCTION):
1.
CHECK HEIGHT OF PUMP ABOVE WATER SOURCE. IF HEIGHT IS MORE THAN 14’
(4.3M) PUMP MUST BE MANUALLY PRIMED
2.
CONFIRM INLET HOSE, OUTLET HOSE AND BOTH WATER INTAKES ARE FREE FROM
OBSTRUCTION
3.
CHECK ALL HOSE CONNECTIONS BETWEEN PUMP AND WATER SOURCE FOR LEAKS
(APPLY PETROL-GEL TO O-RINGS IF NECESSARY)
4.
CONFIRM PUMP INLET STRAINER IS CLEAR OF DEBRIS (SEE Figure 6)
5.
WITH THE PUMP TURNED ON, PRESS AND HOLD THE AIR PRESSURE RELIEF VALVE
ON THE FIRST STAGE I FILTER HOUSING UNTIL THE PUMP IS PRIMED (SEE Figure 7)
SYSTEM PRODUCES WEAK FLOW (< 0.50 GPM):
1.
VERIFY (VIA PRESSURE DROP) THAT THE FILTERS HAVE NOT REACHED THEIR
USEFUL LIFE
2.
CHECK ALL PLUMBING CONNECTIONS FOR LEAKS (APPLY PETROL-GEL TO O-RINGS
IF NECESSARY)
3.
CONFIRM INLET HOSE, OUTLET HOSE AND WATER INTAKE ARE FREE FROM
OBSTRUCTION
4.
CONFIRM THE STAGE I AND STAGE II FILTER HOUSINGS HAVE BEEN PURGED OF
TRAPPED AIR
5.
CONFIRM PUMP INLET STRAINER IS CLEAR OF DEBRIS (SEE Figure 6)
6.
USE CAUTION TO VERIFY PUMP IS NOT OVERHEATING, IF SO ALLOW PUMP TO
COOL