Mounting
plate
SOFSTOP TWIN
MECHANISM
Front pickup
mechanism
(in charged position)
Rear pickup
mechanism
(in charged position)
Tow bar
Front
carriage
Dolly wheel
M5 pan head machine screw
Rear
carriage
Tow bar receiver
Front carriage
SofStop cassette
4
c) Slide the front carriage into the track with the tow bar
facing into the pocket.
d) Before fixing the carriage to the cassette, make sure it
has been pushed past the activator. Failure to do so will
damage the pickup mechanism.
Secure the carriage to the cassette with the M5 pan head
machine screw. Tighten with a #2 Phillips drive.
Black plastic stop
(Bi-Parting
units)
Tap this way
to remove
To lower
door
To raise
door
Club end
of wrench
Adjusting
wrench
Mounting
plate
Plunger
pin
Note: The top of the hanger shaft screws into a self-
locking nut. If the hexagonal nut is turned counter
clockwise too far, the shaft will become loose from the
self-locking nut. If the turning resistance suddenly feels
much easier, you have gone too far.
If you raise the door to the maximum height position,
the threaded bolt may contact fixing screw heads. If
required, remove hanger bolt from wheel and remove
2-3mm (1/8”) of thread.
7 Set final activator positions.
a) Loosen the grub screw of the rear activator. Slide it
approximately 2” towards the track notch.
b) Hold the activator setting block inside the back stud and
gently open the door onto it. The activator will slide
along the track into the correct position.
c) Close the door and remove the activator setting block.
Without moving the activator, tighten all four grub
screws.
3.
4. Slide front carriage into the track.
5 Hang the door(s)
.
Position the carriages in the
pocket opening approximately
where the mounting plates
on the door will be located
when the door is in the closed
position.
Slide the door over the T Guide
and into the pocket.
Align the mounting plates
with the hanger bolts of the
carriages.
Door
Track
notch
Activator
setting
block
6
To raise door: Rotate wrench from left to right.
To
lower door: Rotate wrench from right to left.
3
PAGE
Raise the door up so that the round head of the wheel
hanger shaft lines up with the keyhole shaped hole in the
mounting plate.
Depress the plunger using the wheel hanger shaft head
and slide sideways until it snaps into locked position.
Repeat for the other carriage.
6 Adjust the door height
.
When adjusting door height, the wrench should be
horizontal to the nut.
Use the small end of the wrench supplied to rotate the
hexagonal nut at the bottom of the carriage hanger shaft.
DETAIL A
SCALE 1 : 5
DETAIL B
SCALE 1 : 5
M5 pan head
machine screw
Activator
Carriage
Slide carriage
past activator
Notched end
of track
