© Cavity Sliders USA Inc.
Drawings are not to scale.
Another quality product from:
Cavity Sliders USA Inc.
548 Finney Ct, Gardena, CA 90248
Phone: (888) 466 0030
Fax: (310) 769 5824
[email protected]
www.cavitysliders.com
© All copyright and other property in this document is reserved by Cavity Sliders USA Inc.
Details and specifications are subject to change without notice. Whilst all care is taken to ensure
the accuracy of all information, no responsibility will be accepted for any errors or omissions.
CS SOFSTOP™ (O.D. 2012). 10.2018 - ZNI125 / 60721/US
4
PAGE
Activator
setting
block
Door
f) Open the door and remove the activator setting block.
Without moving the activator, tighten all four grub
screws. The activators are now positioned.
Note: Some doors may still bump on the closing jamb
when closing. If this is a concern, a 3M clear dome stop
(or similar) can be used.
8 Track stops
.
Slide the track stop into the track via the carriage
removal notch and loosely tighten so that the track stop
is still able to slide.
Use the door to push the track stop to where you
want the door to stop. Slide the door away and
tighten the track stops using a hex key.
Track stop
Carriage
removal
notch
Track
d) Loosen the grub screw of the front activator
(currently in the temporary position). Move it
approximately 2” towards the pocket.
e) Hold the activator setting block inside the closing
jamb and gently close the door onto it.
10 Removing the door(s)
(for painting, repairs etc).
Fit the club end of the adjusting wrench over the
hexagonal nut at the bottom of the hanger pin.
Use the extended part of the wrench to press down the
plunger pin that protrudes up from the mounting plate.
Once this plunger is fully depressed slide the wrench
sideways towards the plunger pin.
The whole carriage (including the shaft) will now
disengage from the mounting plate.
It is not always easy to slide the wrench sideways.
You may need to relieve the door’s weight by putting a
wedge between door and floor.
Mounting plates with stops: Remove the black plastic
stop that is tightly fitted into the mounting plate by
tapping it out in the direction shown using a hammer and
drift.
9 Insert the track notch cover
if required.
