Cavavin V-041WDZ, Instruction Manual

Page: 39 / 45

39
Shelves
For easy access to the storage content, you must pull the shelves
approximately 1/3 of its depth out of the rail compartment. These wine
cabinets, however, are designed with a notch on each side of the shelf
tracks to prevent bottles from falling. When removing any of these
shelves out of the rail compartment, tilt the shelf as per the diagram
and simply pull out, or push in the shelf until it sits on the support
brackets securely.
To remove the shelves out of the rail pull each shelf approximately 1/3
out. Use a long flat screwdriver to press down the right plastic notch as
shown in Figure [2] and at the same time lift the left plastic notch as
shown in Figure [2]. Then proceed to pull out the shelf slowly.
Reversible Door
WARNING: To avoid accidents during the process of changing the door, we recommend that you get assistance. The
glass door is heavy and may cause injury if dropped.

Please note that the door of model V-265WSZ i
sn’t reversible.

Depending on the type of handle your wine cabinet is equipped with, the door may not be reversible or may
require that a left or right opening door be ordered to change the opening side.
STEPS:
1. Put the cabinet in an open space
2. With the door opened to the maximum angle, take off the decorative nail on opposite side (Drawing 1)
3. Disassemble the pivot core of upper and lower door hinge by the inner six angle screwdriver (Drawing 2)
4. Use a magnet to remove the door shaft core from the two ends of the top of the door (Drawing 3).
5. After discharging the door core, remove the door from cabinet.
6. Remove the upper and lower door hinge with a screwdriver (Drawing 4).
7. Assemble the door on the opposite side with the accessories contain in the accessory bag.
1. Decorative nail
2. Hex Screwdriver
3. Door hinge screw
4. Pliers
5. Door core
6. Slot type screwdriver
7. Upper door hinge
8. Lower door hinge
9. Hex screwdriver
10. Lower door hinge
11. Knife