Figure 1
Familiarize yourself with the controls of the range hood by
reading through Range Hood Operations, Page 12.
Place the range hood on a flat, stable surface. Connect the
range hood to a designated standard outlet (please refer
the product label for the suitable voltage of this unit) and
turn on the range hood. Verify all operations of the range
hood by referring to Range Hood Operations, Page 12.
Place all supplied parts and required hardware on a flat, stable surface and verify the
presence of all supplied parts listed on Page 4.
Carefully remove the white plastic protective coat from the chimney covers and range hood.
NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.
Determine and mark the center line on the ceiling where the range hood will be installed.
Make sure there is proper clearance within the ceiling or wall for exhaust vent.
Due to the weight and size of this unit, please make sure that the support system or
framework being used is stable and secure in the wall or ceiling.
Put a thick, protective covering over counter top, cook top or range to protect from damage
or dirt. Remove any hazardous objects around the area when installing.
Mark the locations of the support mounting bracket holes, ducting cutout (if used) and
power supply cable cutout on the ceiling. Use drill and saber saw or keyhole saw to cut
openings for power supply cable and ducting (see
Venting requirements
and
Electrical
requirements
, Pages 5-8).
If venting to the outside install vent system (see
Venting Methods
, Page 7). Use caulking to
seal exterior wall or roof openings.
Disconnect main electrical supply, prepare and run electrical wiring through ceiling or wall.
Leave approximately 12” of electrical cord hanging from the ceiling. DO NOT restore power
until installation is completed.
Disconnect power cord, remove the aluminum filter by pressing on the latch toward the
direction of solid arrow while holding the metal handle, gently pull the aluminum filter toward
the direction of dashed arrow as shown in Figure 1.
Remove the grease cup by sliding it sideway, see Figure 2 for location of the grease cup.
Set aside the aluminum filters and grease cup until the range hood is properly installed.
If the range hood comes with a glass canopy and has not already been mounted to the hood,
loosen the four canopy screws and washers from the hood top, carefully place the canopy on
the hood top, and loosely tighten the four canopy screws along with washers. DO NOT put
excessive pressure against the glass.
Advanced Preparations:
1.
2.
3.
4.
Preparations:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Pg 10
Preparation
Excessive Weight
Require three or more persons to
move and install this range hood.
Spinal or other bodily injuries
could occur if it is not followed.
10.
Figure 2
Severe Injury
Rotating fan can cause severe
injury. Stay clear of fan when
power is present.
