CommandPro
®
General Purpose & Safety Applications
User Manual
10
9M02-9028-A031-EN
Rev 4
4.1.7 Testing and Repairs
Refer to the applicable section (TRANSMITTER or RECEIVER) for details on transmitter and receiver testing and
repairs.
4.1.8 Programming
Each transmitter and receiver can be programmed for any operating frequency, address code and specific
operating parameters required by the particular system. Each system is fully programmed and tested before
shipment from the factory and should require reprogramming only in the case of managing spare transmitters.
4.1.8.1 Programming Hardware Requirements
The RAC16A Series Programmer is available for most applications. It provides a convenient method for changing
the identity code and making basic application changes to transmitters and receivers.
4.1.8.2 Programming Levels
Most programming changes involve only the assignment of the identity (ID) code. All programming levels,
including those that allow changing time constants, relay assignments and decoding logic are covered in the
RAC16A Series manual.
4.1.9 Options
4.1.9.1 Custom Transmitter Labels
Custom switch labels are available from Cattron to best suit your application.
4.1.9.2 Custom Enclosure
The receivers are normally supplied in a NEMA 4 steel enclosure. A number of other enclosures are available to
meet special ratings.
4.1.9.3 Optional 900 MHz Antenna
An optional 900 MHz antenna is available for special applications that require increased range.
4.1.9.4 Intrinsically Safe
Intrinsically Safe UL-approved systems with NEMA 7 enclosures are available for ratings of up to Class 1,
Division 1, Group D.
