CatonCaster HD422 User Manual
SAFETY PRECAUTIONS
There is always a danger present when using electronic equipment.
Unexpected high voltages can be present at unusual locations in defective equipment and signal distribution
systems. Become familiar with the equipment that you are working with and observe the following safety
precautions.
•
Every precaution has been taken in the design of your CatonCaster HD422 to ensure that it is as
safe as possible. However, safe operation depends on you the operator.
•
Always be sure your equipment is in good working order. Ensure that all points of connection are
secure to the chassis and that protective covers are in place and secured with fasteners.
•
Never work alone when working in hazardous conditions. Always have another person close by in
case of an accident.
•
Always refer to the manual for safe operation. If you have a question about the application or
operation call Caton for assistance.
•
WARNING – To reduce the risk of fire or electrical shock never allow your equipment to be exposed
to water, rain or high moisture environments. If exposed to a liquid, remove power safely (at the
breaker) and send your equipment to be serviced by a qualified technician.
•
To reduce the risk of shock the CatonCaster HD422 must be connected to a mains socket outlet with
a protective earthing connection.
•
For the CatonCaster HD422 the mains plug is the main disconnect and should remain readily
accessible and operable at all times.
The CatonCaster HD422 is equipped with an internal system battery. The CatonCaster HD422 must
be sent to Caton service for replacement of this battery.
•
When installing the CatonCaster HD422 utilizing the DC power supply, the power supply MUST be
used in conjunction with an over-current protective device rated at 50V, 5A, type: Slow-blo, as part of
battery-supply circuit.
•
To reduce the risk of shock and damage to equipment, it is recommended that the chassis grounding
screw located on the rear of the CatonCaster HD422 – be connected to the installation’s rack, the
vehicle’s chassis, the battery’s negative terminal, and/or earth ground.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Page of
5
107
www.catontechnology.com
July 2020 R1
