Catler CG 8030, Instructions For Use Manual

Page: 24 / 28

24
TROUBLESHOOTING
TROUBLESHOOTING
Problem Possible cause What to do
Grinder does
not start after
pressing START|
PAUSE|CANCEL
button • Grinder not plugged in.
• Grinder has overheated.
• Bean hopper not
attached correctly.
‘PLEASE LOCK HOPPER’
will be displayed on LCD
screen.
• Plug power cord into power outlet.
• Remove power plug from power outlet.
Leave for 20 minutes to cool down
before using again.
• Lock bean hopper into position.
Motor starts but
no ground coff ee
coming from
grind outlet • Incorrect button press.
• No coff ee beans in bean
hopper.
• Grinder/bean hopper
is blocked.
• Press START|PAUSE|CANCEL or
PORTAFILTER SWITCH to activate.
• Fill bean hopper with fresh coff ee beans.
• Remove bean hopper. Inspect bean
hopper & burrs for blockage. Replace
parts and try again.
Motor starts but
operates with
a loud ‘racket’
noise • Grinder is blocked with
foreign item or chute
is blocked.
• Moisture clogging
grinder.
• Remove bean hopper, inspect burrs
& remove any foreign body.
• Clean burrs and chute (refer to care
& cleaning on page 20).
• Leave burrs to dry thoroughly before
re-assembling. It is possible to use a hair
dryer to blow air into grinder inlet (lower
burr) to dry.
Unable to lock
bean hopper
into position • Coff ee beans
obstructing bean
hopper locking device.
• Remove bean hopper. Clear coff ee beans
from top of burrs. Re-lock hopper into
position & try again.
Not enough/
too much coff ee
grind • Grind amount requires
adjustment. • Press SHOTS|CUPS button to change
grind amount.
• Use GRIND AMOUNT dial to fi ne tune the
amount ‘more’ or ‘less’.
Portafi lter
overfi lls • It is normal for the correct amount
of coff ee to appear overfi lled in your
portafi lter. Untamped coff ee has
approximately three times the volume
of tamped coff ee.
Emergency stop? • Press START|PAUSE|CANCEL button to
stop operation.
• Unplug power cord from power outlet.