SCTV Clock Assembly Manual
1/24/22
20
Slide one piece of heat-shrink tubing over each wire on the CRT socket, making sure that each piece is
seated against the socket. Shrink all the tubing pieces onto the CRT socket terminals using a match or
lighter for heat, or a heat gun if you have one. It is best to hold the socket assembly by the wires when
doing this, so that you don't burn your fingers. Don't worry, the heat shrink tubing is flameproof.
Clamp the socket in the vise again, then twist together the two wires in each of the following three pairs
of CRT wires. Twist them by holding both wires out at a 20-degree angle from each other, then passing
one over the other repeatedly until they’re in a single cable with about 2 twists per inch.
Violet-Grey
White-Black
Red-Orange
Plug the Molex pins into the large 5-pin and 6-pin connector shells per the table below, using the
photograph above for reference. Again, hold the shell with the large opening facing you and the slots at
the top. In this orientation, pin 1 is on the left end.
Shell
Pin
Color
6 pin
1
Brown
6 pin
2
Red
6 pin
3
Orange
6 pin
4
Yellow
6 pin
5
-
6 pin
6
Green
5 pin
1
Blue
5 pin
2
Violet
5 pin
3
Grey
5 pin
4
White
5 pin
5
Black
