background image

5

AU

Telephone Helpline: 1300225960

Cooking

NOTE: Unit should not be 

operated with lid in situ.

1.  Connect the appliance to the mains power 

supply.

2.  Set the thermostat to the desired temperature. 

The red heat indicator light turns On.

NOTE: 170°C to 180°C is 

suitable for general cooking.

3.  The appliance begins to heat the oil.

NOTE: The red Heat indicator 

light turns On during heat-

up. When the oil is at the set 

temperatures the light turns 

Off.

4.  Once the oil is at the set temperature lower 

the food into the oil using the basket supplied.

5.  Remove the basket from the oil once the food 

is cooked. Shake gently above the oil pan to 

remove any excess oil.

WARNING: The food and oil 

are very hot! Take care when 

removing the basket as oil may 

drip.

Cleaning, Care & 

Maintenance

•  Always turn Off the appliance and disconnect 

from the power supply before cleaning.

•  Always allow the oil to cool before cleaning, 

ideally for at least 6 hours.

•  Check the temperature with a suitable 

probe thermometer; 40ºC is the MAXIMUM 

temperature at which oil should be removed.

•  For best performance, Caterlite recommend 

that the appliance is cleaned after each day of 

operation.

Note: Failure to clean the 

appliance regularly may result 

in premature activation of the 

thermal cut-out switch.

•  Remove the Element/Control Panel for ease of 

cleaning.

•  Empty the oil to clean the appliance thoroughly.

WARNING: DO NOT remove the 

oil pan until AFTER it has been 

emptied.

•  If the oil is to be reused then filtering it before 

refilling the pan will extend the oil’s cooking life.

•  Use a suitable detergent to clean the interior of 

the appliance.

•  Use warm, soapy water and a damp cloth to 

clean the exterior of the appliance.

•  Dry thoroughly after cleaning, and ensure 

there is no water left in the fryer. 

•  A Caterlite dealer or qualified technician should 

carry out repairs if required.

Troubleshooting

If your Caterlite appliance develops a fault, please check the following table before making a call to the 

Helpline. 

Fault

Probable Cause

Solution

The unit is not working The unit is not switched on

Check the unit is plugged in correctly and 

switched on

Plug and lead are damaged

Call Caterlite agent or qualified technician

Fuse in the plug has blown

Replace the plug fuse

Power supply

Check power supply

Internal wiring fault

Call Caterlite agent or qualified technician

Thermal cut-out activated

Press re-set switch on rear of unit

Safety switch not located properly Refit control/element unit

GG198-A_GG199-A_A5_v1_20190807.indb   5

2019/8/7   13:28

Summary of Contents for GG198-A









Reviews: