13
Pump Reassembly
6.3 Lubricate and install shaft seal (10)
with stainless steel flange facing out
(towards pump).
6.4 Press stainless steel flange firmly against
motor flange until completely seated.
6.1 Lubricate and install slinger o-ring (11)
into motor flange by sliding over motor
shaft. Center between shaft seal bore
and back of the slinger seal bore.
6.2 Lubricate and install motor flange
o-ring (12) onto the motor flange.
Loctite and 242 are registered trademarks of the Henkle Corporation
6.5 Hand thread cam (8) with stamped ID
number and small holes facing pump
(clockwise).
6.6 Use spanner wrench and 1/2" open
wrench to tighten cam (8).
NOTE: Apply Loctite® 242® to threads
of motor shaft.
For Threaded
Shaft Units:
