CASTLE TSM-35, Diagnostic Manual, Page: 22 / 22

TSM-35 Screw Pocket Machine Troubleshooting
35.25 – The machine clamps, routes, drills, unclamps but the bit is stuck
in the material:
• If the drill retracts once it is removed from the material
:
o
Adjust the drill delay to spin longer once the drill
begins to retract

Adjust the drill delay (turn clockwise) and
override the drill solenoid using the red
override button. (The drill solenoid is the
last in the stack.)
•
When you release the override
button, the drill should continue to
spin for a few moments. Adjust so
that the drill continues to spin until
it is over halfway through its
retraction. Run a pocket in material,
and confirm that the drill will not
stick.

If the drill delay valve does not change the
amount of time the drill spins after the
solenoid override button is released – the
drill either stops spinning immediately when air is stopped, or never stops spinning
when air is stopped:
•
Replace the drill delay valve ( P00117 ) or the drill delay assembly ( C35005 )
• If the drill stays out after it is removed from the material and the power is off – disconnect main air:

If drill retracts, change drill solenoid ( P49410 )

If drill does not retract even after air has been disconnected, change the super quick
exhaust on the drill feed rate valve assembly (
P10320 ) and remove and clean the
muffler/breather on the drill solenoid ( P00018 )