Stove status
message
Stove in reset
Both red and green LEDs are flashing (0,5s ON – 0,5s
OFF)
Stove in ignition
Green LED flashing (2s ON – 1s OFF)
Stove in operation
Green LED ON ( not flashing)
Stove in shutting down
Red LED flashing (2s ON– 1OFF)
Stove off
Red LED ON (not flashing)
Stove in alarm
Red LED flashing (0,5s ON– 0,5s off)
Stove in ignition after black-out
Red LED flashing (2s ON – 1s OFF)
Note: During the reset state of the stove, in the first seconds after having given voltage, the
green and red LEDs flash simultaneously, and the display of the emergency panel will
display identification codes to 3 digits.
c.4 Turning ON from remote control
After you have connected the power cord to the rear part of the stove, turn the main switch to
the position ( I ). The button will light up and the red LED on emergency panel will be steady
on.
At this point you can use the remote control to operate the stove.
The selector no.4 must be set to REMOTE and the setting of the selector no. 3 has no
influence (MIN-MED-MAX).
The stove is turned ON by pressing the key ON/OFF (key 11) for 2 seconds. After an early
stage that last about 15 minutes, the stove will pass to full operating.
A steady green LED will be on at the emergency panel.
The warm air will be diffuse from both the upper and the lower grilles. (About 60%and
40%).
