Installation
REFLECTA/1
Page E9
Mounting & Operations Manual
Illumination
Optional supply voltages are 220-240 VAC, 115 VAC or 24 VDC, all 40 VA. Choice is made with order. If the
wrong voltage was delivered just replace the illumination bulb by the right one. In case of longer reflection tubes
or by-passes one may use 60 VA bulbs.
As standard the illumination cables will end approximately 150 cm below the binnacle base. Main and
emergency cables are marked. A junction box (yard supply) should be installed near the cable inlet which
allows easy disconnection in case of compass service.
Use glow lamps of type E14 with 14 mm screw socket.
Illumination Dimmer (Extra)
Optionally available are dimmers with or without enclosure for 220-240 VAC, 115 VAC or 24 VDC. According to
international regulations the compass illumination should be of adjustable birightness. Install the dimmer near to
the helmsman´s position.
The dimmers are of rheostat type. Instructions are attached to the dimmers if ordered.
Caution: Wires inside enclosure are not insulated, danger of electric shock! The dimmers generate heat! Make
sure there is sufficient air circulation!
Replacing of the Bulbs
Remove compass from binnacle
Emergency illumination
Main illumination
(Bulb type E14, screw socket)
Alterations / Errors reserved
Cassens & Plath GmbH, Kompasshaus, Am Lunedeich 131, 27572 Bremerhaven, Germany, tel. +49 471 4839990, fax +49 471 48399910
www.cassens-plath.de
,
