CASO DESIGN EMCG 32, Operating Manual

Page: 78 / 216

78

Exterior housing

Clean the exterior surfaces of the device with a damp cloth.

Turntable, grating and rolling ring

The accessories (turntable, grating and rolling ring) must occasionally be removed and
cleaned. Wash the accessories in warm soapy water.

The rolling ring should be cleaned regularly to prevent excessive noise development or
a rotational malfunctions.
The rolling ring can be washed in a mild soapy solution . Please remember to put the
rolling ring back again properly after cleaning it.

Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.
17 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
17.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
17.2 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults.
Error Possible cause Action
The selected program will
not start.
Device door is not closed Close device door
Power plug is not plugged in Plug in mains plug!
Fuse is not activated Activate fuse
The turntable turns jerkily.
Dirt between the turntable and
the base of cooking camber
Remove dirt
Dirt on rolling ring
Cooking vessel too large
Use different cooking
vessel
Food is not sufficiently
defrosted, warmed up or
cooked after preset time
has elapsed.
Incorrectly selected time or
power level
Re-set time and power
level
Repeat process