– 2 –
PAPER SPECIFICATION
1111
Paper Width
79.5 ±0.5 mm (3.13 ±0.02")
Paper Roll Size
Roll diameter: Maximum 80 mm (3.15")
Take-up paper roll width: 80 +0.5/-1.0 mm (3.15 +0.02/-0.04")
Specified Paper
Specified thermal roll paper: NTP080-80
[Paper: TF50KS-E2D Nippon Paper Industries Co., Ltd.]
Packaged roll paper:
[Paper: PD160R-N (Oji Paper Mfg. Co., Ltd.)]
The following paper can be used instead of the paper above:
Paper: HP220AB1 (Mitsubishi Paper Mills Ltd.)
Paper Roll Spool Diameter Inside
12 mm (0.47")
Outside 18 mm (0.71")
The end of the paper roll must be free to come off the spool when finished. It must not be
NOTE:
adhesively attached or attached in another semi-permanent manner.
INTERFACE SPECIFICATION
1111
RS1111C SPECIFICATION
111111
Data Transmission
Serial. EIA RS-232C compliant
Synchronization
Asynchronous
Handshaking
DTR/DSR or XON/XOFF control *
Signal Levels
MARK = -3 to -15 V:
Logic "1"/OFF
SPACE = +3 to +15 V: Logic "0"/ON
Baud Rate
4800, 9600, 19200, 38400 bps *
Data Word Length
8 bits, 7 bits *
Parity Settings
None, even, odd *
Stop Bits
1 or more
Connector (Printer Side)
Male DSUB-9 pin connector
The data word length, baud rate, and parity depend on the DIP switch settings.
*
(Refer to "5. THE DIP SWITCHES".)
RS1111C INTERFACE CONNECTION EXAMPLE
111111
HOST SIDE
(DTE ex.8251)
TxD
RxD
DTR
DSR
RTS
CTS
GND
PRINTER SIDE
(Pin No.)
RxD (2)
TxD (3)
DSR (6)
DTR (4)
GND (5)
