— 15 —
5-5-3. C_SETUP.EXE
Load C_DIAG and press Enter.
POS_check Exist();
= 0001 (If the driver is not exist, No more message and to be error end.)
POS = read ID();
= ca02 (If the ID is wrong, No more message and to be error end.)
POS_read Version();
= 0002 (Version for driver)
board_chk();
= 0001 (If the I/O-PB board is not exist, No more message and error end.)
*******************************************************************************************************
*
DIAG For I/O-PB-12 Ver 0.03
*
*******************************************************************************************************
*
NETWORK TEST ( C_NET CHIP )
*
CPU TEST
*
*******************************************************************************************************
1:
NET START
11:
CPU Software RESET & Set DIAG Mode
2:
NET END
12:
ROM Sum Check
3:
SEND/RECV MODE (Connection)
13:
RAM Check ( Write & Read )
4:
RECS/SEND MODE (Connection)
14:
RAM Check ( Read only )
5:
SEND MODE
(Connection Less) 15:
Ram Check ( Write & Read/ Repeat )
6:
RECV MODE
(Connection Less) 16:
Ram Check ( Read only / Repeat )
7:
SEND MODE
Not allowed
17:
KP_PRINT_OUT
8:
RECV MODE
Not allowed
18:
KP_PRINT_OUT ( Repeat )
19:
ROM & RAM & KP
*******************************************************************************************************
21:
UPS STATUS
98:
DRV INF
22:
UPS DC CUT
99:
END
*******************************************************************************************************
ENTER DIAG Number
:
=>
1)
Input the number and press Enter.
2)
Thereafter testing program, The display will be going back to menu screen as above.
3)
All testing program can quit by <ESC> key, then going back to menu screen.
Note:
1. Test program No. 7 and 8 are not allowed. (Only software testing)
2. In case of that test programming No. 3, 4, and 6 are not working as long as
No. 5 is working, The IRQ setting of C_NET may clash with the other software.
[Each test command programming]
1. NET START
To initialize the Network and Network controller.
You have to install this program first, before using program 3. ~ 6. or after using
the program No. 2.
u_ioctrl ( start ) ret = 0000
Summary of Contents for EX-I/O-PB-12
