Service Bulletin NTR SB 026 96
Magnum Hitch Diagnostic Codes and Service Manual update
Page 19 of 26
7200
SERIES ELECTRONIC HITCH COMPONENTS
Control Module
Up/Down rocker switch
Enable replacement bulb
Position control lever potentiometer 1000 ohms 10% resistance pins A to C.
Hitch rockshaft position potentiometer 1000 ohms 10% resistance pins A to C.
Mechanical travel (rotation)
Load control potentiometer in cab 10,000 ohms 10%
Hitch travel potentiometer in cab 10,000 ohms 10%
112885A2
113663A1
781991C1
114255A2
114255A2
360 degrees
A186061
A186061
Secondary panel
Response potentiometer 10,000 ohms 10% pins A to C
Drop rate potentiometer 10,000 ohms 10% pins A to C
Upper limit potentiometer 10,000 ohms 10% pins A to C
Diagnostic display (will not work on 7100 series)
235010A1
ELIMINATING DRAFT CONTROL FROM THE MAGNUM TRACTOR
Load pins (draft control) can be eliminated from the tractor by simply unplugging the draft pins and
reprogramming the hitch controller. See page 11 step 7 of the Calibration procedure for Electronic
Hitch.
Cover connector ends if draft pins are removed.
Note:
If a "g" appears during calibration, the draft pins or its wiring circuit has failed,
Note:
During calibration a “g” may appear in the diagnostic display. The hitch control module is
asking “Does the system have two load sensing pins?”
Answer no
if the load pins are disconnected by pressing the hitch switch to the up position and then
to the down position (not to the down momentary position).
Answer yes
if draft control is desired and the load pins are connected by pressing the hitch switch to
the momentary position then releasing.
Normally, the control module will sense two pin and not
ask.
Summary of Contents for Magnum 7210
Page 24: ......
