INTRODUCTION
Before you leave the machine:
1. Park the machine on a firm, level surface.
2. Put all controls in neutral or park lock position.
3. Engage the parking brake. Use wheel chocks if required.
4. Lower all hydraulic equipment — Implements, header, etc.
5. Turn off the engine and remove the key.
When, due to exceptional circumstances, you would decide to keep the engine running after you leave the
operator’s station, then you must follow these precautions:
1. Bring the engine to low idle speed.
2. Disengage all drive systems.
3.
WARNING
Some components may continue to run down after you disengage drive systems.
Make sure all drive systems are fully disengaged.
Failure to comply could result in death or serious injury.
W0113A
Shift the transmission into neutral.
4. Apply the parking brake.
General safety rules specific to this machine
Always have the machine moving when in vibration mode. The vibrator bearing only receives lubrication when the
machine is moving.
Do not change the vibration amplitude when driving. It is always necessary to stop first and then select a different
amplitude.
Do not adjust the heating valve control rod while driving.
Do not roll and compact per bearing capacity of subsoil at such a distance from the edge of slopes or trenches, where
hazard of a landslide or a shoulder breaking off (dropping) together with the machine could occur.
Do not roll and compact with vibration at such a distance from walls, cuts, slopes, where their slip (slide) would happen
because the operator and the machine could get covered with debris.
Do not compact with vibration at such a distance from buildings or facilities and equipment within which the risk of
them being damaged due to vibration transfer impact.
General maintenance safety
Keep the area used for servicing the machine clean and dry. Clean up spilled fluids.
Service the machine on a firm, level surface.
Install guards and shields after you service the machine.
Close all access doors and install all panels after servicing the machine.
Do not attempt to clean, lubricate, clear obstructions, or make adjustments to the machine while it is in motion or while
the engine is running.
Always make sure that working area is clear of tools, parts, other persons and pets before you start operating the
machine.
Unsupported hydraulic cylinders can lose pressure and drop the equipment, causing a crushing hazard. Do not leave
equipment in a raised position while parked or during service, unless the equipment is securely supported.
Jack or lift the machine only at jack or lift points indicated in this manual.
51429076 03/04/2018
6
