Case CX130, Manual, Page: 94 / 262

4 - 6
DIAGNOSTIC - SELECTION
CASE TRAINING CENTER
AUGUST 2000
3. Previous failures in the engine DIAG3
This screen is connected to the previous screen (DIAG2) as concerns failures involving the hourmeter.
Example:
The screen above shows that the failure code 0032 (electronic regulator rack position detector) occurred at 1200
H and that failure code 0016 (fuel temperature sender) occurred at 1000 H.
A. the number of hours shown indicates the time at which the failures occurred for the first time since the data was re-
initialised.
B. If you wish to erase the failure codes and the number of hours, press the work mode switch for 10 seconds.
C. When data is erased from screens DIAG2 and DIAG3. it is recorded in the electronic control box memory (this data
is only visible using an external computer).
4. Excavator failure detection DIAG4
Failure code
Example:
The screen above shows a failure in the hydraulic oil temperature sender (0020).
DIAG MODE II H E 0000
3
E 1200 E 0000
E 1000 E 0000
E 0000 E 0000
E: Failure code
DIAG MODE II H M 0000
4
M 0020 M 0000
M 0000 M 0000
M 0000 M 0000
M: Failure code
M0000: No defect
M0010: Transistor output short-circuit
M0020: Hydraulic oil temperature sender
M0030: Fuel level sender
M0040: Pressure detector P1
M0050: Pressure detector P2
M0060: Pump regulating pressure detector
M0070: Starter motor switch
M0080: Attachment or travel pilot pressure switch
M0090: CAN communication circuit
M00A0: Electronic control box re-initialisation
M00B0: Engine electronic control box
M00C0: Boom cylinder pressure