Page 3 of 6
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
C
B
Sensor Adjustment Lower For Short Coverage
Sensor Adjustment Higher For Long Coverage
Fig. 2
Fig. 3
Adjusting the Light Head (B)
Sensitivity of Motion Sensor
● You can adjust the sensitivity of the motion sensor by using the “SENSITIVITY” selector located on the right
side of the bottom surface of the sensor. (See Fig. 5)
● Adjust motion sensor sensitivity to HIGH (H), MEDIUM (M), or LOW (L) to achieve desired performance.
● Approximate range for each setting: 20 ft. (L), 45 ft. (M), 70 ft. (H).
Note: When power is first applied, the light will turn on to 100% brightness. The sensor will take 30 seconds
to warm up.
1. AUTO MODE (nighttime operation only)
After expiration of the warm-up period, the light will enter a 5-minute TEST mode (day and night operation) and be on
at low-level brightness (0-50%). The light will turn to high-level brightness (100%) when motion is detected. It will then
revert to low-level brightness about 5 seconds after motion is no longer detected.
Adjusting the Sensor Head (C)
1. Aim sensor head toward desired detection area, maintaining a
5° - 40° downward angle to allow moisture to drain.
Note: Make sure sensor head is positioned with control knob facing
towards the ground.
2. You can rotate the sensor head (C) up and down to change the
coverage area. (See Fig. 1) Walk through the detection zone at the
farthest distance you wish to detect motion.
Note: Range set too high may increase false triggering.
(See Fig. 2,3)
Fig. 1
1. Gently grasp the light heads (B) and tilt them up or down, left or right to adjust the light coverage area.
Keep the light heads (B) at least 1” (25mm) away from the sensor.(See Fig. 4)
2. Keep the light heads (B) 30˚ below horizontal to avoid water damage and electrical shock.
●
Fig. 4
Fig. 5
Mode
Sensitivity
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
FUNCTION AND OPERATION (continued)
