11
CV072018-1
TIMETABLE
By selecting this menu item and pressing the OK button you access the summary display of each day of the week, divided into 24 hours.
To change the settings of each day, simply select it, in the summary display screen, and press the OK button; At this moment the detail screen
of the selected day will be shown, in which the list of the eight possible time slots (C1-C8) appears, the day of the week in which it is being
operated is shown in the upper left part of the screen.
By selecting a time slot and pressing the OK button you can modify its content, in the time zone modification screen, in addition to the indi-
cation of the day in which you are operating (top left), the graphic summary of the programming valid for the whole day. The parameters that
can be modified are:
- Change / Change X: selecting this line and pressing OK you can change the time zone in which you are operating without returning to the
previous page: using the arrows, you can scroll through the different time zones (1-8), once the desired just press OK.
- Time / Hour hh.mm: selecting this line and pressing OK adjusts the start time of the current time slot: using the arrows increases (arrow up)
or decreases (arrow down) the schedule in 30 minute sections; Once you have located the desired value, press OK. This parameter can take a
value between the beginning of the previous time slot and the start of the next time slot.
- Fan speed / Speed. vent xxx: selecting this line and pressing OK adjusts the fan speed (or pressure / full-scale flow rate for machines without
cop / cav kit). The flow for units with constant flow or pressure for constant pressure units with kit cop / cav required for the current time slot:
using the arrows the three low, medium and high possible values are selected; located the desired value, press OK. These values correspond to
what is established according to the following section (Adjustment of speed levels).
- Post-heating / Poscalent. on / off: the parameter is visible only if the control is configured to manage an air after-treatment device; By se-
lecting this line and pressing OK, it is possible to enable (on) or inhibit (off) the air after-treatment device. Using the arrows, the two possible
values, on and off, are selected. Once the desired value is found, press OK. When the timer mode is selected, it is visible on the screen if the ON
/ OFF timeout is enabled.
summary display
detail of one day a week
Modifiable parameters in the selected time slot
Selection of the time slot to be modified
