20
21
U
SAG
E
Usage
Button
Description
Power On/Off button
• Tap the “Power On/Off“ button on the main control panel, and the ma-
chine makes a beep sound. This will make the key indicator light up in
green and then the machine enters into “working” mode. At the same
time, PM2.5 index, temperature, humidity and air quality are lit and
displayed on the main control panel.
• Touch the “Power On/Off“ button of the operation panel to turn the ma-
chine off. The power indicator lights up in red and will enter into standby
mode.
Mode selection
• Tap on the “Mode” key on the main control panel. If the “Smart” lights
up, the machine is under Smart Mode, and if the “Manual” lights up, the
machine is under Manual Mode.
• When Smart Mode is selected, the Timer Switch and the Air Volume
Switch on the operation panel will automatically be locked. The machine
will automatically adjust the corresponding purification wind speed ac-
cording to the current air quality.
• When selecting the Manual Mode, wind speed can be configured by
adjusting the corresponding function keys according to your desired re-
quirements.
Timer
• If timer function is required, switch to manual mode and tap on the “tim-
er” key to choose “2H,” ”4H,” ”6H” or “8H” as needed.
Wind Speed Adjustment
• Under the Manual Mode, pressing the “wind speed” key will change
the wind speed from “sleep” to “low,” “medium,” and “high.” When it
reaches “high,” tapping the key again returns it to “sleep” level.
Hochvolt-Plasma (only models 460 und 600)
• Under Smart or Manual Mode, tap on the “high voltage plasma“ key on
the main control panel to turn it on or off.
UV Photokatalysator function
• Selecting the Smart or Manual Mode, tap on the photocatalyst key on the
main control panel to turn it on or off.
C
LEA
NI
N
G
Cleaning
We recommend to clean the filters every 3 months.
Step 1:
Open the two door locks of the Aerotronic Purifier by pressing down the locks.
Afterwards, slowly pull out the purifier door.
Step 2:
Remove the four screws located at the backplate and then take the backplate
down.
Step 3:
Slowly remove the electrostatic module that houses the two-zone ion field and
negative ion generator.
Step 4:
Slowly take out the primary filter.
Step 5:
Spray both the module and the filter with cleaning detergent.
NOTE:
Use
ONLY
a neutral detergent for cleaning. Spray evenly and fully, then leave 15
minutes.
Step 1
Step 2
Step 3
Step 4
Step 5
