30
®
3
In tHe wall Bezel replaceMent
WaLL ContRoL and haRdWaRe
(not to scale)
Switch Mounting
Screws (2)
Wall Plate Screws
(2) White
(2) almond
White Wall
Plate(1)
W-84
Wall Control
W-84 Wall Control Bezel Replacement installation
as follows - (in the Wall Replacement):
Step 1a.
locate the two (2) screws holding the switch
plate to the wall control and remove the cover plate
as shown in Figure #1.
Step 1a.
locate the four (4) tabs holding the bezel to
the front of the switch, then press in on each tab one at
a time, removing the bezel as shown in Figure #2.
Step 1b.
locate the rubber key pad attached to the
four (4) locating pins as shown in Figure #2 and
remove rubber key pad from the wHItE bezel, also
as shown in Figure #2.
Switch Bezels
(1) White
(1) almond
Figure #1
almond Wall
Plate(1)
SCReWS
(2)
WaRninG!
To avoid possible electrical shock, make cer-
tain that electricity is turned off at the circuit
breaker or fuse box before attempting any in-
stallation or repair procedure
CAutIoN! Not turning the power oFF at the
circuit breaker or fuse box may cause damage
to the electronics within the wall control and/
or the PC board on the fan.
Figure #2
BeZeL
BeZeL
taBS
White Wall
(4) Wire Cap
Summary of Contents for Holliston
Page 37: ...35 Holliston...
