Press
key once to set
up the low limit. The display
shows "0.000" and the first
number flashes.
Press the
key until
the display shows "WL
OFF". "WL OFF" means
that comparator function
is not activated.
11
10
Press
key to activate
this function. The display
shows "WL ON".
LO
5. Comparator Function - HI / LOW Limit Setting (SW-1C only)
Press the
key to have
number increase. To move
flash to next digit, press
the
key.
Press
key to set up HIGH
limit. The display shows
"0.000" and you can change
these numbers by pressing
key. If you want to move
to next digit you can go by
pressing
key.
If you set up HIGH limit you
can go out by pressing
key, and you can see "ENd"
message shortly and "WL
on" message on the display.
LO
HI
If you set up HIGH limit and LOW limit incorrectly, "Err" will be shown on the display.
Then you may need to set it up again. For example, LOW LIMIT=2.990 kg and HIGH
LIMIT=1.990 kg this is incorrect setting because HIGH limit is lower than the LOW limit.
When HIGH and LOW limit are set as the same or above maximum capacity it still shows
"Err" message.
If you want to go back to the
simple weighing mode just
press
key twice.
Suppose that the HIGH limit and
LOW limit are set up as 2.990kg
and 1,990kg respectively. If the
weight loaded is 2kg between
HIGH and LOW limit the display
shows "OK" and the scale
continues to beep slowly.
If the weight loaded is above
2.990kg, HIGH limit, the scale
continues to beep rapidly.
LO
OK
kg
kg
6. Counting Function
(SW-1C only)
Counting without Tare
Initial display as above.
Press
key twice to go
to sample unit selection
mode.
Press
key to select the
number of sample unit. You
can select 10, 20, 30, 40,
50,60, 70, 80, 90, 100, 200,
300,400, or 500 as a sample
unit.
kg
pcs
pcs
