6 Programming
42
For Label Type = 1 or 2, you will
always see this screen.
Label Type 0
is the standard fixed sized label media with liner backing paper. The Length value is the
length of the label itself. To capture the Length value, press the ALT key twice. The scale will feed out
several labels and automatically detect the length and the gap size. Please make sure that you have
standard “gapped” labels in the printer whenever you execute this procedure.
Label Type 1
is continuous strip label media with liner backing paper. The
Feed
value determines the
amount of labels/paper to feed when you press the
FEED
key. The
Feed
value can be 0 mm to 170 mm.
Label Type 2
is continuous strip label media or receipt thermal paper
both without
liner backing paper.
Type to works the same as Type 1 except that the pick-up motor will not operate as there should be no
liner to pick-up.
The
Width
value is the width of the label or paper and NOT the width of the liner backing paper. It must
be specified in millimeters. If this value is incorrect then some label formats may print properly but no
receipts will print properly. Please make sure to set this value properly. The
Width
can be from 20 mm to
80 mm.
The
Rcpt Feed
value is the amount of blank space to feed after each receipt or label is printed. This is
done so that the paper cut can tear the receipt or label properly. The
Rcpt Feed
can be from 0 mm to
170 mm. The
Rcpt Feed
is only for type 1 or 2.( recommendation Rcpt Feed is 15mm )
Remember that you can press
SAVE
at any time or the
ENTER
key while the cursor is on the last field in
order to save the current screen contents and return to the previous menu. The
ESC
key exits and
returns to the previous menu.
6.2.7 Adjust Feed Length
Once at the
SET: Settings
menu screen, press the
7
key. The Adjust Feed Length screen will appear as
follows:
The Feed Adjustment is a fine adjustment that controls the print position from top-to-bottom on a label.
The higher the number, the higher the printing will appear. The lower the number, the lower the printing
NUMERIC
< SET: ADJUST FEED LENGTH >
Feed Adjustment :[100] (0-200)
Use FEED key to test.
Use SAVE or ENTER key to save