FCC ID:2ABK7MA202R
IC ID:11629A-MA202R
FCC ID:2ABK7MA202R
IC ID:11629A-MA202R
FCC ID:2ABK7MA202R
IC ID:11629A-MA202R
L
O U TP U T
R
L
O U TP U T
R
L
O U TP U T
R
L
O U TP U T
R
1
2 0 V~
T
5 AL
6
0 Hz 350 W
2 3 0 V~
T
2 .5 AL
5
0 Hz 350 W
0 0
Bridged Dual Mono Connection
This diagram shows two MA202R amplifiers connected to 2 full range speakers, each in a bridged
configuration. The crossover switch is in the FLAT position. The RCA inputs are split so that each
channel is fed into the LEFT RCA input at the amplifier. The LEFT input is the mono input for the
bridged configuration. The speakers should be no less than 8 Ohms. This configuration allows
the greatest channel separation and increases the individual power for each speaker.
This configuration delivers
150 watts into each 8 Ohm
speaker. You MUST use a
speaker with a minimum of
8 Ohms nominal impedance
for the bridged configuration!
This connection diagram
shows a typical use of two
MA202R’s in a “dual mono”
stereo configuration with each
one driving a single full range
speaker. This setup is ideal
for a maximizing power to a
speaker that requires 150 watts
instead of 75 watts. You would
gain roughly 3dB in output over
a single amplifier configuration
using this method.
This diagram shows two MA202R amplifiers in a “Daisy Chain” configuration. Using the LINE OUT
RCA jacks, you can pass signal through the MA202R on to other MA202R amplifiers. Based on how
you want the amplifiers after the first one is configured, you can select stereo or mono operation.
It’s advised to use the stereo amplifiers first in the signal chain and then break off to the mono
configurations when using multiple MA202R amplifiers.
Daisy Chained MA202R Amplifiers
This connection diagram
shows a typical use of two MA202R’s
running an entire full bandwidth,
multi-speaker system. This
setup is ideal for a using small
“book shelf ” style main speakers
and a separate discrete
subwoofer to reinforce the low
frequency content.
This configuration delivers
75 watts into each 4 Ohm
stereo speaker (on the left).
You can also use 8 Ohm
speakers in this
configuration
This configuration also
delivers 150 watts the 8 Ohm
subwoofer. You MUST use a
speaker with a minimum of
8 Ohm nominal impedance
for the bridged configuration!
11
1
2 0 V~
T
5 AL
6
0 Hz 350 W
2 3 0 V~
T
2 .5 AL
5
0 Hz 350 W
0 0
1
2 0 V~
T
5 AL
6
0 Hz 350 W
2 3 0 V~
T
2 .5 AL
5
0 Hz 350 W
0 0
FCC ID:2ABK7MA202R
IC ID:11629A-MA202R
FCC ID:2ABK7MA202R
IC ID:11629A-MA202R