GB
// 14
a) Programming using the LCD program box:
You can use this box to adjust various settings on your speed
controller quickly and easily.
Before starting programming, please remove the 3-pin connector
on the speed controller.
Now use this socket on the controller to connect the 3-pin plug
(white / red / black) on the programme box (please observe red +,
black -).
Next switch the speed controller on. After a short time 2 values will
appear on the LCD.
You can now use the buttons marked “Item” (select 1 to 6) and
“Value” (Program selection 1-9) to change various values (see
following tables).
Once you have changed a setting, confirm it by pressing the “OK”
button.
You can restore the speed controller back to its factory settings by
pressing the “Reset” button.
Once again press the “OK” button again to confirmm.
ProgrammIng tHe SPeeD controLLer
Protection Function
a) Low voltage cut-off protection:
If the voltage of a lithium battery pack is lower than the threshold
for 2 seconds, the ESC will cut of the output power. Please note that
the ESC cannot be restarted if the voltage of each lithium cell is
lower than 3.5V.
For NiMH battery packs, if the voltage of the whole NiMH battery
pack is higher than 9.0V but lower than 12V, it will be considered
as a 3 cell lithium battery pack; If it is lower than 9.0V, it will be
considered as a 2 cell lithium battery pack.
For example, if the NiMH battery pack is 8.0V, and the threshold is
set to 2.6V/Cell, so it will be considered as a 2 cell lithium battery
pack, and the low-voltage cut-off threshold for this NiMH battery
pack is 2.6*2=5.2V.
b) Over-heat protection:
When the temperature of the ESC is over a factory preset threshold
for 5 seconds, the ESC will cut off the output power.
c) Throttle signal loss protection:
The ESC will cut off the output power if the throttle signal is lost for
0.2 second.
Alert tones
Input voltage abnormal alert tone:
The ESC begins to check the input voltage when power on, if it is
out of the normal range, such an alert tone will be emitted: “beep-
beep-, beep-beep-, beep-beep-” (There is 1 second time interval
between every “beep-beep-” tone).
