Carson 1181280, Installation Instructions Manual

Page: 5 / 12

5
3. Install block-off cover (item 16 pg 2) using one (1)
# 8 x 1 1/4" PWH screw (item 6 pg 2). See Fig. 4.
(Use caution to assure screw does not penetrate
vehicle roof ).
4. Detach wire harness from brace where A/C assembly
was removed. Remove and retain two (2) OEM
screws. Trim headliner to clear front flange of rear
mounting bracket (item 17 pg 2) Insert rear mounting
bracket tabs in existing slots on rear of OEM brace.
Align holes of bracket with OEM bracket. Secure
with OEM screws. See Figure 5. Route wiring
toward driver’s side of bracket. Install convoluted
tube (item 11 pg 2) around wire harness to prevent
chaffing against bracket.
5. Remove and retain two (2) OEM screws located
at front of OEM bracket near windshield. Mount
front bracket (item 13 pg 2) using OEM holes and
OEM screws. See Figure 6.
Figure 4
Figure 5
Figure 6