9
7. Remove A/C control from rear bezel assembly. Modify A/C control by drilling three (3) 1/8" dia. holes
in front mounting tabs. Position rear A/C control head in center of overhead opening. Secure with five
(5) # 6 X 3/8" PPH screws (item 2 pg 2). See Figure 14.
8. If vehicle is equipped with OEM vent switches,
remove and discard blank plug in new overhead console.
Retain four (4) screws. Remove and discard four ( 4 )
screws from OEM console. Remove and modify switch
assembly by trimming four ( 4 ) tabs flush with edge.
Install two ( 2 ) mounting brackets (item 15 pg 2 ) using
four ( 4 ) 6-32 X 3/4" screws (item 5 pg 2 ) and four (4)
keps nuts (item 1 pg 2). Install and secure OEM vent
switch assembly using four ( 4 ) screws previously
removed. See Figure 15.
Important:
Be sure vent switch assembly is centered in
console openings. Manually push switch buttons to
check for proper clearance and function.
IV. INSTALLATION OF OVERHEAD CONSOLE.
Caution: Do not overtighten screws. Use extra support for the console until secured to the vehicle.
Failure to do so may cause damage to console or installed components.
Figure 14
Figure 16
Figure 15
Summary of Contents for 1181280
Page 3: ...3...
Page 12: ...12 CUT ON DOTTED LINES...
