Carrier TYLER Advantage NLBN, Installation & Service Manual

Page: 23 / 27

Installation & Service Manual NLBR, NLBN, NLBS
April, 2007 Page 23
Lift Glass End Seal Replacement
The end seal trim for the curved glass edge
is designed to slide on the glass without the
need for glue or other adhesives. Looking
at the cross section, you will notice a slight
protrusion on the underside of the trim. This
protrusion helps prevent the seal trim from
coming off the glass once the trim piece has
been properly installed.
1. Lift the glass to the fully opened position.
2. Thoroughly clean the edge of the glass (1)
and the end seal trim (2) by wiping with
alcohol. Dry both surfaces.
3. Starting at the top edge of the glass (1),
push on the end seal trim (2) with the pro-
trusion lip against the inside glass surface.
4. Cut off any excess end seal trim that
extends beyond the bottom edge of the
glass. Close the lift glass.
PARTS INFORMATION
Operational Parts List
Case Usage Domestic
Electrical Circuit 115 Volt 60 Hertz
Case Size 59” 77”
Primary Fan Motor (NLBR/NLBS) 5125532 5125532
5 Watt 5 Watt
Opt. Export Primary Fan Motor 5126572 5126572
(NLBR/NLBN)(220 Volt 50 Hertz) 5 Watt 5 Watt
Primary Fan Motor Brackets (NLBR/NLBS) 5962269 5962269
Primary Fan Bracket Plate (NLBR/NLBS) 9041077 9041077
Primary Fan Blades (7” 15° 5B)(NLBR/NLBS) 5223891 5223891
Vent Fan Motor (NLBR/NLBS) 5120747 5120747
Vent Fan Blades (3” 4B)(NLBR/NLBS) 5120748 5120748
Opt. ECM Fan Motor (NLBR/NLBS) 9025002 9025002
8 Watt 8 Watt
Opt. ECM Fan Motor Brackets (NLBR/NLBS) 9025005 9025005
Opt. ECM Fan Blades (7” 15° 5B)(NLBR/NLBS) 5223891 5223891
Lighting Ballast (2-lamp) 5991029 5991029
(3-lamp) 5991030 5991030
T-8 Lampholder (canopy & shelf) 9041897 9041897
Anti-Sweat Heater Wire (NLBR/NLBS) 5217424 5228677
Thermostat (NLBR/NLBS) 5940375 5940375
NSF Product Thermometer 5967100 5967100
For information on operational parts not listed above contact the TYLER Service
Parts Department.