Carrier TYLER Advantage NLBN, Installation & Service Manual

Page: 16 / 27

NLBR, NLBN, NLBS
Page 16 April, 2007
Cleaning Instructions
WARNING
TYLER Refrigeration does not recommend the use of high pressure cleaning equipment on
service style cases!! The sealing of front glass and end joints is critical in these cases and
high pressure cleaners can penetrate and/or damage these seals. Damaged seals allow
water leaks and/or air leaks that can cause poor case refrigeration.
CAUTION
• When cleaning this case, try not to intro-duce water into the case faster than it can be car-
ried away by the waste outlet.
• Liquid chlorine bleach is corrosive to metals. The use of bleach or products containing
bleach will damage metal surfaces and void the case warranty.
• Sanitize the case with Quaternary Ammonium Solutions (ex: KAYQUAT II, J-512 Sanitizer,
SANIQUAT 512, etc...) approved per 21CFR 178.1010, followed by adequate draining and
air drying. These solutions may be obtained from Kay Chemical Co., Johnson Wax
Professional, Coastwide Laboratories, etc....
• Always use a soft cloth or sponge with mild detergent and water to clean the front glass.
Never use abrasives or scouring pads to clean glass. They can scratch and/or damage
the glass.
See “General (UL/NSF) I&S Manual” for case cleaning instructions. Stainless steel cleaning
is covered in the following chart.
Stainless Steel Cleaning Methods
The cleaning data in the following stainless steel cleaning chart was supplied by AISI. The information was supplied by
Prime Metals Division, Alumax Aluminum Corporation.
TYPE OF CLEANING CLEANING AGENT* APPLICATION METHOD** EFFECT ON FINISH
Routine cleaning Soap, ammonia or deter- Sponge with cloth, then Satisfactory for use on all
gent and water. rinse with clear water and finishes.
wipe dry.
Smears and finger- Arcal 20, Lac-O-Nu, Lumin Rub with cloth as directed Satisfactory for use on all
prints Wash O’Cedar Cream on the package. finishes. Provides barrier film
Polish, Stainless Shine
Stubborn spots and Allchem Concentrated Apply with damp sponge or Satisfactory for use on all
stains, baked-on Cleaner cloth. finishes.
splatter, and other light
discolorations
Samae, Twinkle, or Cameo Rub with damp cloth. Satisfactory for use on all
Copper Cleaner finishes if rubbing is light.
Grade FFF Italian pumice, Rub with damp cloth. Use in direction of polish lines
whiting or talc on No. 4 (polished) finish.
May scratch No. 2 (mill) and
No. 7 and 8 (polished) finishes.
Liquid NuSteel Rub with dry cloth. Use a Use in direction of polish lines
small amount of cleaner. on No. 4 (polished) finish.
May scratch No. 2 (mill) and
No. 7 and 8 (polished) finishes.
Paste NuSteel or DuBois Rub with dry cloth. Use a Use in direction of polish lines
Temp small amount of cleaner. on No. 4 (polished) finish.
May scratch No. 2 (mill) and
No. 7 and 8 (polished) finishes.