![background image](http://html.mh-extra.com/html/carrier/performance-edge/performance-edge_owners-manual_2564114014.webp)
12
QUICK START
Setting or changing the temperatures for heating and cooling
Your thermostat is installed with pre
−
set heating and cooling temperature
settings. You can use these or change them so your home is as warm or as cool as
you would like it to be. You can also temporarily change the temperature after
you’ve programmed your thermostat according to your specific schedule needs.
These steps will temporarily hold the temperature where you set it for two hours
until the next programmed cycle begins.
1. Open the door. You will see an arrow next to the word
heat
or
cool
in the
upper right corner on the screen, depending on the mode your system is
in. (If it’s the first time you’ve used the thermostat, it will say
heat.
) The
pre
−
programmed heating or cooling temperature is displayed in a box at
the bottom of the screen.
2. To change the displayed temperature, press the
up
or
down
button located on the right side of the display until
you reach the desired setting.
3. To change the other temperature, press the
mode
button
above the screen. The arrow will move to the word
cool
or
heat
and the screen will show that temperature in a
box in the lower right corner.
Summary of Contents for Performance EDGE
