Configuring IP for the i-Vu® CCN Router
i-Vu® CCN Router
CARRIER CORPORATION ©2021
Installation Guide
All rights reserved
6
The i-Vu® CCN Router must be commissioned using Network Service Tool on
Port S1
.
1
Use
Network Service Tool V
(NST V) to connect the i-Vu® CCN Router directly into Port S1, which is
designated for CCN communications.
2
Upload the i-Vu® CCN Router (Default CCN Address 0, 1).
NOTE
After uploading the controller the CCN address should be changed to something other than 0,1. This
avoids addressing conflicts when uploading Carrier equipment into the i-Vu application. When using NSTV the
CCN address can be changed by highlighting the i-Vu® CCN Router and then clicking on the Display/set
properties icon.
3
Access the
Service Configuration Table
IP_CONF to enter the following configuration options:
NOTE
A static IP address is required, as DHCP is not supported.
○
Host IP Address
- enter the device manager's IP address, provided by the LAN administrator (allowable
entries for xxx.xxx.xxx.xxx: xxx is a decimal number between 0 - 255)
○
Subnet Mask
- enter the device manager's IP address, provided by the LAN administrator (allowable
entries for xxx.xxx.xxx.xxx: xxx is a decimal number between 0 - 255)
○
Default Gateway
- enter the IP Gateway's IP address, provided by the LAN administrator (typically a
router on the Ethernet LAN).
CCN ENET Configuration
Device Type
-
○
Select
0
for
Gateway
if the converter connects the primary CCN Bus (Bus 0) to the Ethernet. Toggle the
spacebar to select
0
.
○
Select
1
for
Bridge
if the converter connects a secondary CCN Bus to the Ethernet. Toggle the spacebar
to select
1
. The CCN Element number of the CCN Bridge becomes the CCN secondary bus number
assigned to controllers residing on the network.
NOTE
You can only have one Gateway per system.
If configured as a Bridge:
○
CCN/Ethernet Gateway Address
- enter the IP address of the i-Vu® device manager that is configured as
the CCN Ethernet Gateway. This is the same address that was entered in the Host IP address for the CCN
Gateway. (Entries are allowed for xxx.xxx.xxx.xxx:xxx are decimal numbers between 0 - 255.)
NOTE
When the device manager is configured as the Gateway, it ignores the CCN/Ethernet Gateway IP
address. In this case, leave the CCN/Ethernet gateway address at its default setting (0.0.0.0.).
4
Repeat the above steps for each i-Vu® device manager used in the CCN system.
Configuring IP for the i-Vu® CCN Router
Summary of Contents for i-Vu CCN Router
Page 4: ......
Page 16: ......
Page 17: ...CARRIER CORPORATION 2021 Catalog No 11 808 393 01 1 22 2021...
