GB - 6
Dehumidification
3
4
5
6
7
8
9
10
11
1
2
TURBO
SILENT
TURBO
SILENT
5 MIN.
The dehumidification only function should be used if you want
to remove moisture from the room air without lowering the
temperature.
Place the unit in the space to be dehumidified (room, garage,
cellar or storeroom).
Plug the unit in.
Open the air flow direction guide vane.
Turn the mode selector to the dehumidification symbol.
The dehumidification indicator light
on the control panel is illuminated.
The air conditioner removes moisture from
the air without lowering the temperature.
If the two red indicator lights
on the control panel light up,
this shows that the condensate water
collection tank is full.
If this is the case the unit automatically
switches off.
To empty the tank, switch the unit off by
turning the mode selector to the symbol.
Remove the plug from the power
supply socket.
Remove the outdoor unit if it is attached to
the indoor unit.
Take out the full water tank on the rear
side of the air conditioner and empty it.
Then replace it correctly in its position.
If the dehumidification mode
is again required, plug in the unit
and wait 5 minutes before
again turning the mode selector
to the dehumidification symbol.
In certain applications a floor drain may
be provided and it may be easier to use
the drain tube to remove the condensate
water directly. Proceed as follows:
• pull out the 60 mm long condensate
drain tube and remove the plug.
• Connect the drain tube to the floor drain
using a rubber tube.
After use remember to put the plug into
the drain tube and to replace
the tube in its position.
