background image

Air Purifier

Quick Start and Installation Guide

RECOMMENDED INSTALLATION PAIRINGS

NOTE: A qualified installer or agency is required for proper installation. This guide is 

for reference only and it is not intended to replace the product Installation Instructions.

The first two models noted below 

are designed to be installed 

with furnaces, while the last 

three models are designed to be 

installed with fan coils. 

Note:

  Air Flow Sensor Accessory 

Kits are available if your 

installation does not match 

these recommendations  

– see KIT160000,  

or KIT161000. 

Models DGAPAXX1625, DGAPAXX2025, DGAPAXX1620, DGAPAXX2020, DGAPAXX2420

There are three main mounting 

options for the air purifier product 

– top mount, bottom mount, or 

side mount. The location of the 

Air Purifier should be readily 

accessible. Enough room 

should be provided for periodic 

replacement of the Air Purifier 

cartridges.

1

MOUNTING OPTIONS FOR AIR PURIFIERS

2

DGAPAXX1625 DGAPAXX2025 DGAPAXX1620 DGAPAXX2020 DGAPAXX2420

Furnace

X

X

Fan Coil

X

X

X

Return Duct

Top Mount

Bottom Mount

Return Duc

t

Side Mount

Airflow

Airflow

Airflow

Summary of Contents for DGAPA 1625 Series

Page 1: ...sory Kits are available if your installation does not match these recommendations see KIT160000 or KIT161000 Models DGAPAXX1625 DGAPAXX2025 DGAPAXX1620 DGAPAXX2020 DGAPAXX2420 There are three main mounting options for the air purifier product top mount bottom mount or side mount The location of the Air Purifier should be readily accessible Enough room should be provided for periodic replacement of...

Page 2: ...ound Chassis A Route the power conduit from the purifier to a knockout on the furnace that provides access to the EAC terminals on the furnace control board Affix the end of the conduit to the furnace using the included conduit fitting B Attach the quick connect terminals on the wires exiting the power conduit assembly to the furnace EAC 1 and EAC 2 spade connections Attach the ground ring termina...

Page 3: ...els including an airflow sensor Make sure flow sensor is clean and unobstructed Flow sensor is damaged for models including an airflow sensor Replace flow sensor available as replacement kit KIT160000 Flow sensor bypass assembly is damaged for models without an airflow sensor Replace flow sensor bypass assembly available as replacement kit KIT161000 One or more of the three airflow sensor contact ...

Page 4: ...ll be displayed after 10 seconds purifier will not operate until cause of error condition is rectified and purifier is reset An error code was registered in the purifier controls prior to the purifier being turned off The purifier controls may be reset during the 10 seconds in which the LED is flashing rapidly see the Reset Procedure on previous page if the problem persists follow the actions reco...

Reviews: