![background image](http://html1.mh-extra.com/html/carrier/classicool-53kdht60n-518/classicool-53kdht60n-518_instruction-manual_2561127023.webp)
21
14. INSTALLATION OF WIRED ROOM CONTROLLER
14.1 SAFETY PRECAUTION
Read the safety precautions carefully before installing the wired controller.
Stated below are important safety issues that must be obeyed.
Conform there is no abnormal phenomena during test operation after complete.
Meaning of marks:
WARNING
Means improper handling may lead to personal death or severe injury.
CAUTION
Means improper handling may lead to personal injury or property loss.
WARNING
Please entrust the distributor or professionals to install the wired controller.
Installation by other persons may lead to imperfect installation, electric shock or fire.
Improper installation may lead to electric shock or fire.
Reinstallation must be performed by professionals.
Improper installation may lead to electric shock or fire.
A random disassembly may cause abnormal operation, which may result in fire.
CAUTION
Do not install the wired controller in a place vulnerable to leakage of flammable gases.
Once flammable gases are leaked and left around the wire controller, fire may occure.
The wiring should adapt to the wire controller current.
Otherwise, electric leakage may occur and result in fire.
The specified cables shall be applied in the wiring. No external force may be applied to the terminal.
Otherwise, wire cut and heating may occur and result in fire.
14.2 OTHER PRECAUTIONS FOR WIRED CONTROLLER
Installation Location
: Do not install the wired controller in a place with much oil, steam, sulfide
gas. Otherwise, the product may deform and fail.
Preparation of wired controller before installation :
1. Confirm that all the following parts are supplied.
No.
Name
Qty.
Remarks
1
Wired controller
1
Inside carton box of wired controller
2
Cross round head wood mounting
screw
3
GB950-86 M4X20
(For Mounting on the Wall)
3
Cross round head mounting
screw
2
M4X25 GB823-88
(For Mounting on the Electrical Switch Box)
4
Plastic expansion pipe
3
For Mounting on the Wall
5
Plastic screw bar
2
For fixing on the 86 electrician box
6
Switching wires for signal
receiving board
1
For connecting the signal receiving board
and 4-core shielding wire
7
Switching wires for wire
Controller
1
(If needed) For connecting the main control
panel and 4-core shielding wire
8
Switching wires for wire controller
signal
1
For connecting the indoor unit connector
and 4-core shielding wire
2. Prepare the following assemblies on the site.
No.
Name
Qty.
Remarks
1
Electric cabinet
1
Universal electric cabinet’s specification.
Pre-embed it into wall.
2
Wire configured tube
( insulated sheath )
1
Pre-embed into wall, the longest length
should not exceeding than 15m.
3
Phillips screwdriver
1
For install cruciform slot screw.
4
Slotted head screwdriver
1
For unscrew the bottom cover of wired controller
Notes to installation of wired controller :
1. Circuit of Wired Controller is low voltage circuit. Never connect it with a standard 220V/380V
circuit or put it into a same Wiring Tube with the circuit.
2. The shield cable must be connected stable to the ground or transmission may fail.
3. Do not attempt to extend the shield cable by cutting, if it is necessary, uses Terminal
Connection Block to connect.
4. After finishing connection does not use Mugger to have the insulation check to the signal wire.
Summary of Contents for ClassiCOOL 53KDHT60N-518
Page 57: ......