Carrier CDG-105EA, Owner'S Manual

Page: 5 / 144

4
CONTROL PADS ON THE DEHUMIDIFIER
NOTE: The control panel of the unit you purchased may be slightly different according to the
models.
Control pads
3
When you push the pad to change
operation modes, the unit will make
a beep sound to indicate that it is
changing modes and the corresponding
indicators in Display Window illuminate.
Fig.1
2
Humidity Set Control Pads
: Down/Up Pads
TIMER Set Control Pads
Use the Up/Down pads to set the Auto start and
Auto stop time from 0.0 to 24.
The humidity level can be set within a range of
35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.
For drier air, press the pad and set to a lower
percent value(%).
For damper air, press the pad and set a higher
percent value(%).
Display Window
Shows the set % humidity level from 35% to 85% or
auto start/stop time (0~24) while setting, then shows
the actual(
±
5% accuracy) room % humidity level
in a range of 30%RH(Relative Humidity) to 90%RH
(Relative Humidity).
Error Codes and Protection Codes:
AS
- Humidity sensor error--Unplug the unit and plug it
back in. If error repeats, call for service.
ES - Temperature sensor error-- Unplug the unit and
plug it back in. If error repeats, call for service.
5
Timer Pad
Press to initiate the Auto start and Auto stop feature,
in conjuction with the and key pads.
1
4
Power Pad
Press to turn the dehumidifier on and off.
Mode Pad
Press to select the desired operation mode from
Dehumidifying,Dryer,Continuous dehumidifying and
Smart dehumidifying.
NOTE: Dryer and Smart dehumidifying modes are
optional.
6
Fan Pad
7
Ion Pad(optional)
Press to activate the ionizer. Anions ar automatically
generated by ionization. The anions deactive the
airborne chemical vapors and dust particles. Press
it again to stop the function.
Control the fan speed. Press to select either High
or Normal fan speed. Set the fan control to High for
maximum moisture removal. When the humidity has
been reduced and quiet operation is preferred, set
the fan control to Normal.
8
P1 - Unit is defrosting-- Allow the unit time to automati-
cally defrost. The protection will clear after the unit self
defrosts.
P2 - Bucket is full or bucket is not in right position--
Empty the bucket and replace it in the right position.
E3 - Unit malfunction-- Unplug the unit and plug it back
in. If error repeats, call for service.
Timer
Ion Fan
ON
OFF
ON OFF
Mode
Power
3
7 6 5 4 2 1
8
Indicators on Display Window:
-Displays when the Filter operation is on (unavilable
on this unit).
-displays when Bucket is full.
-Displays when Normal Fan function is set.
-Displays when High Fan function is set.
NOTE:When the Display Window is dark,
first press any Pads (except the Power
Pad) to make the Display Window light,
press again to set desired operation
modes.