GB - 5
E N G L I S H
B
A
PREPARATION
Cooling with dehumidification
A
B
Cooling with dehumidification
CONTROL
PANEL
INFRARED
REMOTE CONTROL
Cooling with
dehumidif.
1
2
3
6
7
10
15
11
12
IMPORTANT
When the room air temperature is above 30
°
C, the fan motor is switched automatically to run at high speed.
2
3
8
B F E
Insert the air outlet vent into end
B
of the
flexible pipe.
Move the air
conditioner close
to the window,
stretching the hose
as little as possible
(max. extension
1100 mm).
Place the air outlet
vent of the flexible
hose outside the
window.
The flexible pipe supplied with the unit is
positioned at the rear of the unit.
Insert end
A
into the connection
provided.
WATER PUMP
DRAINAGE:
Connect the water pump drain
hose to the unit before
operation.
When the water in the internal
tank will reach a
predetermined level, the
water pump will be activated
and the condensate will be
drained out thought the
connected drain hose.
DO NOT FORGET TO
CONNECT DRAIN HOSE.
CONTINUOUS
DRAINAGE:
When you plan to leave the unit
unused for a long time or you
need continuous drainage,
remove the rubber blockage from
the lower back hole and attach a
tube of the right dimension to
drain hose connector. All the
condensate in the water tank
would be drained
outside through the lower drain
hose during operation. Under
this condition the water pump is
not activated.
• Switch on the unit by pressing button
1
.
• Using the function selector (button
2
), select the COOLING mode. For
confirmation, the cooling LED
15
will light up on the control panel.
• By pressing the temperature selector (button
6
), select the desired temperature
which will appear on the display
7
.
• Using the fan speed selector (button
3
), select the fan speed desired (low,
medium or high). For confirmation, the LED
10
or
11
or
12
will light up on the
control panel according with the fan speed selected.
• Switch on the unit by pressing button
8
.
• Using the operating mode function selector
(button
2
), select the COOLING mode. For
confirmation, the arrow of operating mode
display (B) will indicate the mode chosen.
•By pressing the temperature selectors (buttons
1
and
9
), select the desired temperature which
will appear on the display area (F).
• Using the fan speed selector (button
3
), select
the fan speed desired (low, medium or high).
For confirmation, the arrow of fan speed
display (E) will indicate the fan speed chosen.