![background image](http://html1.mh-extra.com/html/carrier/53p100c/53p100c_owners-and-installation-manual_2561769026.webp)
• It is best for the piping to go through the wall behind the unit. So that the unit hides the pipes.
• For this method of installation, make a 65mm diameter hole in the wall at either point L or R. ( Figure. 5 )
• Drill a hole at a slope so that the outside end is lower ( 5-10mm ) than the inside end
to ensure good drainage.
• Cut the Wall Sleeve to match the wall thickness and to pass the pipe through the hole.
( Figure. 6 )
185
500
105
• Remove the knock-out in the unit and pass the pipes through the wall.
• The pipe should slope downward and away from the unit to ensure good drainage.
23
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901
2) Making the Wall Penetration for the Interconnecting Piping
Rear Piping
Figure 5
Side or Bottom Piping
Figure 6
Indoor side
5~10mm lower
Outdoor side
INDOOR UNIT INSTALLATION
42KP5P5402B_I
2004.3.30, 6:35 PM
Page 5
Adobe PageMaker 6.5K/PPC