BAFFLE HEATER COMPONENT IDENTIFICATION
& REMOVAL INSTRUCTIONS
1.
Baffle Heater
2.
Light Switch
3.
Light Receptacle – Lefthand side
When light switch is ON, baffle heater
is de-energized.
NOTE:
Disconnect the power supply before
servicing the cabinet.
The baffle heater is located just behind the light fixture
at the warm air intake to coil.
The baffle can be accessed by removing screws located
at the bottom edge of V baffle. The heater is attached at
the back side of the V baffle with self-adhesive tape.
The heater resistance can be checked by unplugging
the heater at the plug-in connector on the lefthand end
of the light channel. The heater is only energized when
the light is turned OFF.
CAUTION:
1
1
1
1
1
1
1
1
2
2
2
2
3
3
3
3
30
MAINTENANCE & REPAIR
Summary of Contents for 52-2038-01
